How to Install a Pulse Board in a 1992 Cadillac Brougham

If you want to install a new pulse board in your 1992 Cadillac Brougham, you may be wondering how to do it. The answer to this question may vary depending on the car model. For example, a Corvette pulse board will work on an F-body, but you may need to change some wiring. Likewise, the same board should work on early FWD A-bodies, such as the Cutlass Ciera and the Pontiac 6000.

Replace wiper motor

To replace the wiper motor on your 1992 Cadillac Brougham, first remove the wiper arm from the wiper transmission. This piece of equipment is secured to the wiper assembly by means of bolts. Remove the top bolt with a socket and extension and then remove the wiper motor. Be sure to follow the factory repair information to ensure that the wiper assembly is removed correctly and is not damaged in the process.

If the wiper motor is moving but not wiping, there is a problem with the wiper module. The internal circuit inside the wiper motor sends an electrical signal under the dashboard. The signal is not accurate if it does not indicate the time for the wiper blades to move. A professional mechanic will be able to replace the wiper module to ensure proper operation of the vehicle’s wipers.

Replace wiper switch

If you’re having trouble with your wipers, you might need to replace the wiper motor pulse board. You can purchase a replacement for about $30 at your local Advance Auto Parts store. This is far cheaper than having to replace the wiper motor itself. To replace the wiper motor pulse board, remove the wiper motor housing and three screws. Make sure to seal the edges of the new board with silicone.

Next, you’ll need to remove the wiper/washer control connector. You’ll then need to connect a multimeter to the contacts of the wiper switch and check for resistance. If you find that there’s a problem, clean and replace the wiper/washer control connector.

Replace wiper blades

There are two ways to replace wiper blades on a 1992 Cadillac Brougham. The first method involves removing the old wiper blade from the vehicle by pressing a small button or latch. Then, you should pull it backwards until the hook is visible and remove it. The new wiper blade should have the hook over the wiper arm attachment. After removing the old blade, you should discard the packaging material.

Next, you should check the wiper motor. The wiper motor controls the speed of the wiper blades. It connects to the wiper arms through a linkage. The wiper motor may be the cause of the problem. Before replacing the wiper motor, make sure that you check the wiper switch.

If the wiper blades are intermittently operating, the intermittent wiper relay may be damaged. This will prevent the wiper motor from working correctly. It may also cause the wiper motor to overheat.